Skip to content

Home / Lift Stations

Cellular Lift Station Alarm Monitoring & Pump Control

Stop sanitary sewer overflows before the neighbors call. Watch wet-well levels, pump runtimes, alternation failures and AC power loss on one screen, with dual AT&T and Verizon cellular and no long-term contract.

Start 30-Day Free TrialCompare vs. Mission Communications

Why operators choose TankVitals for lift stations

One S2C alarm unit per station watches the wet well, the pumps and the power, and calls your crew when something drifts out of range.

S2C cellular alarm unit for a wastewater lift station

Dual-carrier cellular redundancy

Remote stations often sit in low-lying ground with spotty reception. The dual-SIM modem connects to both Verizon and AT&T, so your alarms keep reporting when one network drops.

Catch clogs and seal failures early

Track up to 4 pump run timers and add clamp-on CTD current sensors to spot long runtimes, short-cycling or high-amp draw before a pump burns out.

Wet-well level and float monitoring

Connect any 4-20 mA transducer or ultrasonic sensor, plus your existing high-water floats, to watch levels around the clock.

Callouts that find a person

When high water or power loss hits at 2:00 AM, your on-call operator gets a voice call, text and email.

Power loss and restoration alerts

Know the moment a station loses AC power and the moment it comes back.

Runtime logs for compliance

Export daily pump runtime and temperature history to a graph or a file for state and municipal records.

S2C input mapping for a duplex or triplex panel

Here is how the S2C connects to the signals an existing lift station panel already has.

Input Capacity Typical lift station use
Analog inputs Four 4-20 mA Wet-well level transducer, flow meter, pump amperage through CTD sensors
Alarm inputs Up to 12 High and low floats, pump overload, seal leak, phase loss, generator status
Pump run timers Up to 4 Start counts, run hours, alternation faults
Relay output 1 Remote alarm reset, backup pump trigger or beacon control
Temperature Built-in probe Warn of heater failure in freezing weather
Gray polycarbonate hinged enclosure with two latches

Planning an upgrade? Read the step-by-step lift station retrofit guide.

Simple, published pricing

S2C unit: $2,000 one time

Includes the unit, voice, text and email alerts, 2 year history and a lifetime circuit board warranty.

Single carrier plan: $30/month

AT&T or Verizon, month to month, cancel anytime.

Redundant plan: $49/month

AT&T and Verizon on one dual-SIM modem, month to month, cancel anytime.

Blue split core current transducer with green terminal block

Lift station monitoring questions

How does it install on an existing control panel?
The S2C installs as an overlay alongside your existing duplex or triplex panel. It wires into auxiliary float contacts, pump run signals and 4-20 mA level transducers without interfering with your pump alternator logic.
What happens if a station loses power or cellular signal?
The S2C detects AC power loss and alerts your on-call operator. With the dual-SIM modem option, the unit switches between Verizon and AT&T if one carrier has an outage.
Can it track pump runtimes and alternation failures?
Yes. The S2C supports up to 4 pump run timers and optional clamp-on CTD current sensors, so you can log daily run hours and catch a pump that stops or never shuts off.

Try it on your toughest lift station

30 days free, no card. Tell us about your sites and we will ship a unit and set up your dashboard.

Start 30-Day Free TrialCall 701-352-4696